Hot End completo in metallo MK10 Micro Swiss 0.3mm

Disponibilità immediata

€ 46,00

Cod. Prod.: MS-201003

quantità:
+
Aggiungi al Carrello

COMPATIBILE CON:


Wanhao I3 - I3v2.1 - I3plus


Wanhao D4 ultima versione


Wanaho D6

Dettagli

Hot End Completo dalla Micro Swiss per estrusori Wanhao MK10, ugello 0.3mm

Kit di modifica completo per hot end in metallo rivestito per lte prestazioni. Il kit include anche la barriera termica e l'ugello modificato

Questo kit vi permetterà di aumentare considerevolmente la velocità di rammollimento del filamento, incrementando così la velocità di stampa mantenendo inalterata la qualità
Thermal barrier tube is made from 2 different materials. The lower thermal break is made from stainless steel, and the colder upper part is made from aluminum. Stainless steel was used for thermal break because it offers low thermal conductivity, and aluminum was used for the upper portion because it has a lot better thermal conductivity, to carry away any heat from the filament. All metal hotend will let you print at much higher temperature then possible with original PTFE lined one. Another benefit of an all metal hotend design is more consistent melt chamber control. During slow extrusion rate, in PTFE lined hotend, transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With all metal design a transition zone is always constant, being located right at the heat break. With fast extrusion rate, PTFE tube doesn't have enough thermal conductivity to properly melt all the plastic coming out. On MK10 extruders that limitation happens around 60 mm/s, depending on nozzle size. All metal hotend solves this problem, plastic is surrounded by thermally conductive nozzle throughout its length. Kit includes 1 nozzle and 1 thermal tube.